topic no username prompt after session to CX Module on ASA5545-X in Network Security

no username prompt after session to CX Module on ASA5545-X

yao yu jiang — Tue, 12 Mar 2019 02:29:15 GMT

I HAVE asa5545 , i shutdown the ips , and unintsall the ips software module, and reload the asa, account to 9.1 configure cli guide, and upload the asa cx boot image, and reboot the cx module, wait 5 min, session cx console, i see the

# session cxsc console

Opening console session with module cxsc.

Connected to module cxsc. Escape character sequence is 'CTRL-^X'.

but there is no user/password prompt

i am expectiong the prompt to login . the session is just blank

I exist to ASA, and show module, it still show the cx module recover .

i tried many time, even reboot the ASA, Still can not see the user login prompt in the cx console ?

anyone know this problem ?

when I show the module,

isee

Mod Card Type Model Serial No.

---- -------------------------------------------- ------------------ -----------

0 ASA 5545-X with SW, 8 GE Data, 1 GE Mgmt ASA5545 FCH1705J14G

ips Unknown N/A FCH1705J14G

cxsc Unknown N/A FCH1705J14G

Mod MAC Address Range Hw Version Fw Version Sw Version

---- --------------------------------- ------------ ------------ ---------------

0 b0fa.eb97.b9f5 to b0fa.eb97.b9fe 1.0 2.1(9)8 9.1(2)

ips b0fa.eb97.b9f3 to b0fa.eb97.b9f3 N/A N/A

cxsc b0fa.eb97.b9f3 to b0fa.eb97.b9f3 N/A N/A

Mod SSM Application Name Status SSM Application Version

---- ------------------------------ ---------------- --------------------------

ips Unknown No Image Present Not Applicable

Mod Status Data Plane Status Compatibility

---- ------------------ --------------------- -------------

0 Up Sys Not Applicable

ips Unresponsive Not Applicable

cxsc Recover Not Applicable

no username prompt after session to CX Module on ASA5545-X

Marvin Rhoads — Wed, 21 Aug 2013 23:14:50 GMT

Hmm. Yes the recover status plus lack of login prompt indicates the CXSC module has not completed its boot.

Did you use the commands:

sw-module module cxsc recover configure image disk0:/asacx-5500x-boot-9.1.2-21.img

(or later image version - however it is important that you use the boot image first to bootstrap)

sw-module module cxsc recover boot

If you didn't, then I would try to shutdown, uninstall and re-try using those commands in addition to an uninstall (first) as follows:

sw-module module cxsc shutdown

(wait until show module indicates it is shutdown)

sw-module module cxsc uninstall

I am having the same issue.

mbaker33 — Mon, 10 Mar 2014 15:46:31 GMT

I am having the same issue. HOwever, when I try the commands above, it does not seem to help. When I issue the uninstall command, it returns a message indicating that there is no software available to uninstall. Also, when I look at the logs, it shows the correct version and appears to be waiting at a login prompt of sorts.

Any further input would be greatly appreciated.