topic Active Active Multiple context Failover command config in Network Security

Active Active Multiple context Failover command config

mahesh18 — Tue, 12 Mar 2019 02:15:00 GMT

Hi Everyone,

When we config failover interface on ASA which is in multi context mode and is active active.

We do that in system space with this command.

failover lan int F1 GigabitEthernet0/2

failover interface ip F1 192.168.50.x 255.255.255.0 standby 191.168.50.x

Do we need to config the above command on two contexts also??????????

I checked current setup where i see above command on system space but not on context admin and x.

Regards

MAhesh

Message was edited by: mahesh parmar

Jouni Forss — Sat, 20 Jul 2013 17:58:24 GMT

Hi,

You do the Failover configurations only in the System Context space of each ASA unit.

You can check this from the ASA Command Reference for example. It usually lists the modes in which they are usable.

Lets take for example the 2 commands you mention.

This is from the 8.4 software level Command Reference

The tables in the below text show which mode the command is supported on.

The following table shows the modes in which you can enter the command:

The following table shows the modes in which you can enter the command:

- Jouni

mahesh18 — Sat, 20 Jul 2013 18:13:38 GMT

Hi Jouni,

Many thanks again.

Best regards

Mahesh