active/active failover

jw445ozzy — Tue, 12 Mar 2019 02:02:02 GMT

How do I make the primary the secondary and vice versa. 192.168.1.10 should be the primary/active and 192.168.1.100 should be the secondary/standby. Thanks.

John

show failover

Failover On

Failover unit Primary

Failover LAN Interface: failover Ethernet0/2 (up)

Unit Poll frequency 1 seconds, holdtime 15 seconds

Interface Poll frequency 5 seconds, holdtime 25 seconds

Interface Policy 1

Monitored Interfaces 6 of 250 maximum

Version: Ours 8.2(1), Mate 8.2(1)

Group 1 last failover at: 20:59:12 EDT Jun 22 2013

Group 2 last failover at: 20:59:12 EDT Jun 22 2013

This host: Primary

Group 1 State: Standby Ready

Active time: 0 (sec)

Group 2 State: Standby Ready

Active time: 0 (sec)

slot 0: ASA5510 hw/sw rev (2.0/8.2(1)) status (Up Sys)

aux-470-fw Interface outside (192.168.1.100): Normal

aux-470-fw Interface inside (192.168.1.100): Normal

aux-865-fw Interface outside (0.0.0.0): Normal (Waiting)

aux-865-fw Interface inside (0.0.0.0): Normal (Waiting)

aux-864-fw Interface outside (0.0.0.0): Normal (Waiting)

aux-864-fw Interface inside (0.0.0.0): Normal (Waiting)

slot 1: empty

Other host: Secondary

Group 1 State: Active

Active time: 139935 (sec)

Group 2 State: Active

Active time: 139831 (sec)

slot 0: ASA5510 hw/sw rev (2.0/8.2(1)) status (Up Sys)

aux-470-fw Interface outside (192.168.1.10): Normal

aux-470-fw Interface inside (192.168.1.10): Normal

aux-865-fw Interface outside (192.168.1.250): Normal (Waiting)

aux-865-fw Interface inside (192.168.1.250: Normal (Waiting)

aux-864-fw Interface outside (1192.168.1.190): Normal (Waiting)

aux-864-fw Interface inside (192.168.1.190): Normal (Waiting)

slot 1: empty

Re: active/active failover

Shaoqin Li — Mon, 24 Jun 2013 15:13:05 GMT

do u want to separate the active/stdby role to two ASAs?

e.g.

hostname(config)#failover group 1
hostname(config-fover-group)#primary
hostname(config-fover-group)#exit
hostname(config)#failover group 2
hostname(config-fover-group)#secondary
hostname(config-fover-group)#exit

Sent from Cisco Technical Support iPad App

active/active failover

jw445ozzy — Mon, 24 Jun 2013 18:10:27 GMT

On the unit I wanted to make primary:

failover active group 1

This resolved my issue. Thanks.

topic Re: active/active failover in Network Security

active/active failover

Re: active/active failover

active/active failover