topic ASA IOS Upgrade in Network Security

ASA IOS Upgrade

millarbrown — Tue, 12 Mar 2019 00:34:45 GMT

Preparing to upgrade the IOS on a faillover pair of ASA 5580's and was wandering what is gonna happen after I've upgraded the IOS on the standby unit and rebooted. How is the active unit going to react when it sees an IOS mismatch prior to me making the standby the primary and upgrading it's IOS ?

Thanks, for any help.

ASA IOS Upgrade

Eugene Korneychuk — Fri, 07 Dec 2012 18:46:32 GMT

Hello Andrew,

There shouldn't be any problems, please follow this guide to perform upgrade on failover pair:

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/mswlicfg.html#wp1057338

Please rate helpful posts

Best Regards,

Eugene

ASA IOS Upgrade

julomban — Fri, 07 Dec 2012 18:47:12 GMT

Andrew,

During the upgrade in failover there is going to be a mismtach for a few minutes between each other. It should not be a problem if it is only a few minutes.

The correct procedure is below:

-Copy the binary image (asannn.bin) to the root directory of the TFTP server.

-Issue the copy tftp flash command in order to copy the new ASA image to the Primary ASA.

-Issue the copy tftp flash command in order to copy the new ASA image to the Secondary ASA.

2- On the Active (Primary) Firewall:

-No boot system flash:

-boot system flash:

-write memory

-failover reload standby

-no failover active

-reload

3- On the Standby (Secondary) Firewall:

-no failover active

Regards,

Juan Lombana

Please rate helpful posts.