topic ASA5520 9.0(1) basic config in Network Security

ASA5520 9.0(1) basic config

jayturish — Tue, 12 Mar 2019 00:25:10 GMT

Folks,

I have an asa5520 runing 9.0 that I want to setup for simple NAT, i,e 4.3.2.1/30 on the outside 192.168.1.1/24 on the inside with dynamic NAT outbound. The new IOS has thrown me for a loop.. I have everything working except the NAT. Can somebody do an SDM screen shot of the Dynamic NAT entry? Even if the IP's are different, I can figure it out...

Also, is there a way to make the unused ethernet interfaces gig0/2 and 0/3 into switch ports on the internal net?

(or VLAN like you could do on the 5505)?

ASA5520 9.0(1) basic config

lcambron — Tue, 20 Nov 2012 03:40:51 GMT

Hello,

This Guide should help you:

http://www.cisco.com/en/US/docs/security/asa/asa83/asdm63/configuration_guide/nat_objects.html#wp1074591

for internet access, look at "Configuring Dynamic PAT (Hide)" Section.

Regards,

Felipe.

ASA5520 9.0(1) basic config

lcambron — Tue, 20 Nov 2012 03:44:26 GMT

Also, you cannot use the interfaces as switchports, this is possible only on the ASA5505.

Regards,

Felipe.