topic active/standby in multiple context mode in Network Security

active/standby in multiple context mode

john.dejesus — Tue, 12 Mar 2019 00:17:09 GMT

is active/standby configuration possible in multilple context mode? i cannot find an article regarding this matter.

Re: active/standby in multiple context mode

Julio Carvajal — Thu, 01 Nov 2012 04:42:08 GMT

Hello John,

It is available

Actually the ones you need are the regular ones (documents) as the ASA will trigger failover if one of the context fail

Important Notes

For multiple context mode, the ASA can fail over the entire unit (including all contexts) but cannot fail over individual contexts separately.

. Active/Standby Failover is available on units that run in either single or multiple context mode. Both failover configurations support stateful or stateless (regular) failover.

VPN failover is not supported on units that run in multiple context mode as VPN is not supported in multiple context. VPN failover is available only for

Active/Standby Failover configurations in single context configurations.

With this I think you are ready to start configuring it:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Julio

Re: active/standby in multiple context mode

john.dejesus — Thu, 01 Nov 2012 06:22:28 GMT

got it. thanks. i was able to configure it and it was successful. thanks. appreciate it.

Re: active/standby in multiple context mode

Julio Carvajal — Thu, 01 Nov 2012 06:31:40 GMT

Hello John,

My pleasure

Regards,