topic Can a Transparent mode firewall use /30 and still work. in Network Security

Can a Transparent mode firewall use /30 and still work.

smooth1966dha — Tue, 12 Mar 2019 00:07:25 GMT

Here is my question, I have a ASA 5510 that is connected to my ISP and the inside interface that is connected to my router. I have a /30 and need to determine if the configuration of x.x.x.121/30 which is my ISP and also the BVI address on the ASA. The inside router address is x.x.x.122/30 same subnet as my ISP will allow me to pass traffic. Management interface works using a different ip address but not able to get the traffic to pass traffic out to the internet thru the ASA

ISP-------->ASA-------->Router

Bottom Line is that I only have one usable address that is being used by the router and the ISP and ASA are using the other. Will this work?

Can a Transparent mode firewall use /30 and still work.

fb_webuser — Wed, 10 Oct 2012 18:32:04 GMT

Transparent firewall needs a management ip address in the same subnet as the passing traffic. Also please check the vlans of the switch port (if any) of the outside and inside interfaces. The vlans needs to be different for both interfaces.

---

Posted by WebUser Fawad Khan from Cisco Support Community App

Can a Transparent mode firewall use /30 and still work.

Julio Carvajal — Wed, 10 Oct 2012 19:19:22 GMT

Hello Eugene,

As the web user post the ASA needs to be on the same broadcast domain than the other 2 devices you have (isp modem and router) so the managment Ip needs to be there and needs to be different than the one used by the other devices. /30 will not work.

Remember to rate all of the questions the community answers.

Regards,

Julio

Can a Transparent mode firewall use /30 and still work.

fb_webuser — Thu, 11 Oct 2012 02:34:18 GMT

ASA should have a BVI interface configured with ip address in same broadcast domain. his BVI interface id should be ae configured as bridge group in both inside and outside interfaces

---

Posted by WebUser Sujith Rs from Cisco Support Community App

Can a Transparent mode firewall use /30 and still work.

smooth1966dha — Thu, 11 Oct 2012 05:03:34 GMT

Thanks for everyone quick replies. Requested a /29 and that solved the problem.