ASA ASDM issue

terry.davis — Fri, 21 Feb 2020 11:39:19 GMT

All,

I have a Cisco ASA 5510 with an IPS module in it. When trying to

connect to this unit with ASDM on port 8443 I get an error

"Certification Validation Error" and on the popup it is asking for

the password. I put in the enable password and then it comes back

and asks for the username and password again and you end up in a

loop until it comes back and says that it cannot connect to the

appliance. I am able to connect to appliance with SSH utilizing the

same username and password. My unit is running ASA software 8.2.1

and the 6.2.1 ASDM software.

Any ideas on what I need to correct this error?

Re: ASA ASDM issue

andrew.prince — Thu, 03 Sep 2009 10:07:26 GMT

check your config

you may need:-

aaa authentication http console LOCAL - which means to auth the HTTPS session with the local username/password.

HTH>