https://community.cisco.com/t5/network-security/firesight-active-disovery/m-p/2956631#M43517 <P>Can I do Firesight Active Discovery when Firepower is configured in monitor-only mode.</P> <P></P> Sun, 10 Mar 2019 13:41:58 GMT mysubscription99 2019-03-10T13:41:58Z https://community.cisco.com/t5/network-security/firesight-active-disovery/m-p/2956631#M43517 <P>Can I do Firesight Active Discovery when Firepower is configured in monitor-only mode.</P> <P></P> Sun, 10 Mar 2019 13:41:58 GMT https://community.cisco.com/t5/network-security/firesight-active-disovery/m-p/2956631#M43517 mysubscription99 2019-03-10T13:41:58Z https://community.cisco.com/t5/network-security/firesight-active-disovery/m-p/2956632#M43518 <P>Yes, you can integrate FireSIGHT/FMC with AD even if the sensors are running in monitor-only mode.&nbsp;</P> <P>I hope this helps!</P> <P><EM>Thank you for rating helpful posts!</EM></P> Wed, 19 Oct 2016 00:37:33 GMT https://community.cisco.com/t5/network-security/firesight-active-disovery/m-p/2956632#M43518 nspasov 2016-10-19T00:37:33Z https://community.cisco.com/t5/network-security/firesight-active-disovery/m-p/2956633#M43521 <P>Hello Team,</P> <P>Refer the following link if that link helps you.</P> <P>http://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118738-configure-firesight-00.html</P> <P>Rate helpful posts.</P> <P>Regards</P> <P>Jetsy&nbsp;</P> Wed, 19 Oct 2016 06:37:31 GMT https://community.cisco.com/t5/network-security/firesight-active-disovery/m-p/2956633#M43521 Jetsy Mathew 2016-10-19T06:37:31Z