topic p to p in Network Security https://community.cisco.com/t5/network-security/p-to-p/m-p/1917552#M436339 <P>I all we are going to terminate point to point link between 3750 and 6506.</P><P></P><P></P><P></P><P></P><P></P><P></P><P>on 6506</P><P></P><P></P><P>int gi1/45</P><P>no switchport access</P><P>ip address 192.X.0.x 255.255.255.0</P><P>no shut </P><P></P><P></P><P></P><P></P><P>routes</P><P></P><P></P><P>ip route 172.16.X.0 255.255.255.0 192.168.0.53</P><P></P><P></P><P>172.16.200.1 is the vlan created on 3750</P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P>on 3750 stack switch</P><P></P><P></P><P>int gi1/01</P><P>no switchport</P><P>ip address 192.X.0.x 255.255.255.0</P><P>no shut </P><P></P><P></P><P></P><P></P><P></P><P></P><P>ip route 0.0.0.0&nbsp; 0.0.0.0 192.168.0.54</P><P></P><P></P><P>vlan created </P><P></P><P></P><P>int vlan 220</P><P>ip address 172.16.X.1 255.255.255.0</P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P>Does this config correct as i am configuring between stack switch and 6506</P> Mon, 11 Mar 2019 23:09:32 GMT prashantrecon 2019-03-11T23:09:32Z p to p https://community.cisco.com/t5/network-security/p-to-p/m-p/1917552#M436339 <P>I all we are going to terminate point to point link between 3750 and 6506.</P><P></P><P></P><P></P><P></P><P></P><P></P><P>on 6506</P><P></P><P></P><P>int gi1/45</P><P>no switchport access</P><P>ip address 192.X.0.x 255.255.255.0</P><P>no shut </P><P></P><P></P><P></P><P></P><P>routes</P><P></P><P></P><P>ip route 172.16.X.0 255.255.255.0 192.168.0.53</P><P></P><P></P><P>172.16.200.1 is the vlan created on 3750</P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P>on 3750 stack switch</P><P></P><P></P><P>int gi1/01</P><P>no switchport</P><P>ip address 192.X.0.x 255.255.255.0</P><P>no shut </P><P></P><P></P><P></P><P></P><P></P><P></P><P>ip route 0.0.0.0&nbsp; 0.0.0.0 192.168.0.54</P><P></P><P></P><P>vlan created </P><P></P><P></P><P>int vlan 220</P><P>ip address 172.16.X.1 255.255.255.0</P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P></P><P>Does this config correct as i am configuring between stack switch and 6506</P> Mon, 11 Mar 2019 23:09:32 GMT https://community.cisco.com/t5/network-security/p-to-p/m-p/1917552#M436339 prashantrecon 2019-03-11T23:09:32Z p to p https://community.cisco.com/t5/network-security/p-to-p/m-p/1917553#M436340 <HTML><HEAD></HEAD><BODY><P>Hello Prashant,</P><P></P><P></P><P>The configuration looks good to me!</P><P></P><P>The right routes, right interface configuration.</P><P></P><P>Regards,</P><P></P><P>Julio</P></BODY></HTML> Tue, 22 May 2012 04:25:42 GMT https://community.cisco.com/t5/network-security/p-to-p/m-p/1917553#M436340 Julio Carvajal 2012-05-22T04:25:42Z