topic failover configuration query in Network Security

failover configuration query

amit bhatnagar — Mon, 11 Mar 2019 23:02:44 GMT

hi ,

I have a cisco asa 5510 with security plus license in Live enviroment .

I need to add a secondary firewall .

I was planning to do in active /standby mode for failover .

But i have a doubt , when i do "show version " on live asa output says Active /active failover , does this means that i can only configure failover in active/active mode not in active/standby (which i want to do )?

please advice

sh ver

...

Licensed features for this platform:

Maximum Physical Interfaces : 8

VLANs : 20, DMZ Unrestricted

Inside Hosts : Unlimited

Failover : Active/Active

VPN-DES : Enabled

VPN-3DES-AES : Enabled

VPN Peers : 25

WebVPN Peers : 2

Dual ISPs : Enabled

VLAN Trunk Ports : 8

AnyConnect for Mobile : Disabled

AnyConnect for Linksys phone : Disabled

Advanced Endpoint Assessment : Disabled

UC Proxy Sessions : 2

This platform has an ASA 5505 Security Plus license.

failover configuration query

varrao — Sat, 05 May 2012 21:02:20 GMT

If you have active/active license, you can configure active/standby as well, but if you only have active/standby then you cannot configure active/active failover.

Thanks,

Varun

failover configuration query

Mohamed Sobair — Sat, 05 May 2012 21:03:51 GMT

Hello,

This is means it supports Active/Active Failover as well, So your Firewall now supports both Active/Standby and Active/Active Failover configuration.

HTH

Mohamed

failover configuration query

amit bhatnagar — Sat, 05 May 2012 21:12:00 GMT

thanks varun / mohammad for confirmation

how will i know in already exiting firewall in failover that it is active/active or acctive /standby ?

regards

amit

failover configuration query

varrao — Sat, 05 May 2012 21:25:41 GMT

Hi Amit,

active/active failover is done by creating contexts, you can check it by:

show failover

this output would show you if it is active/standby or active/active.

Read through this configuration docs as well, it would help:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080834058.shtml?referring_site=smartnavRD

Hope that helps,

Thanks,

Varun