Can not access FWSM via session command in cisco 6513 (VSS enabled)

ahmed.gadi — Mon, 11 Mar 2019 22:58:27 GMT

Dear All,

Today i received FWSM from cisco (RMA), I need to configure it as standby unit for existing FWSM active/standby setup.

IOS on RMAed FWSM is 2.3.4 and cisco VSS supports FWSM IOS 4.0.4 and later.

My issue is, I cannot access FWSM (IOS 2.3.4) via session command from cisco 6513 but could successfully consoled it without any problem. I have reloaded it twice and also tried to disable and enable power on it.

VSS#sh module switch 2

Switch Number: 2 Role: Virtual Switch Standby

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

2 6 Firewall Module WS-SVC-FWM-1 -----------

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

2 0034.2fd7.3b04 to 0019.2fa7.3b0b 4.2 7.2(1) 2.3(4) Ok

Mod Online Diag Status

---- -------------------

2 Pass

VSS#session switch 2 slot 2 pro 1

The default escape character is Ctrl-^, then x.

You can also type 'exit' at the remote prompt to end the session

Trying 127.0.1.21 ...

% Connection timed out; remote host not responding

Can someone please let me know why I cannot access FWSM through session command ?

Whether this is because of older IOS ? If yes then how to upgrade its IOS ?
Is it possible to upgrade IOS via FWSM console ? if yes, please let me know.
Do i need to test on different slot ?

Look forward to hearing from someone.

Thanks & Regards

Ahmed...

Can not access FWSM via session command in cisco 6513 (VSS enabl

Jeroen Wittock — Tue, 01 May 2012 11:35:27 GMT

There is a limitation that FWSM running version older than 4.0.4 will not accept session from the switch if the FWSM is not seated into switch 1 AND if switch 1 is not active.

So to upgrade the FWSM you either need to use the console or put the FWSM physically in switch 1.

Thanks,

Jeroen

Re: Can not access FWSM via session command in cisco 6513 (VSS e

ahmed.gadi — Tue, 08 May 2012 07:26:41 GMT

Many thanks Jeroen. I tried to console it but no options to upgrade but YES after connecting it to active chasis i could access it through session command.

topic Re: Can not access FWSM via session command in cisco 6513 (VSS e in Network Security

Can not access FWSM via session command in cisco 6513 (VSS enabled)

Can not access FWSM via session command in cisco 6513 (VSS enabl

Re: Can not access FWSM via session command in cisco 6513 (VSS e