https://community.cisco.com/t5/network-security/firesight-simulation-mode/m-p/2868296#M43915 <P>Hello Tejas,</P> <P>Did you mean the monitor only mode ?</P> <P>Monitor only mode just sends a copy of the traffic and no actions will be taken on that traffic.</P> <P>Rate if this answer helps you.</P> <P>Regards</P> <P>Jetsy&nbsp;</P> Wed, 18 May 2016 18:21:57 GMT Jetsy Mathew 2016-05-18T18:21:57Z https://community.cisco.com/t5/network-security/firesight-simulation-mode/m-p/2868295#M43914 <P>is it possible to run a firesight sensor in "simulation" mode ? i.e can it show if a particular access control policy was enforced what would be allowed and what would be blocked ?</P> <P></P> <P></P> Sun, 10 Mar 2019 13:37:16 GMT https://community.cisco.com/t5/network-security/firesight-simulation-mode/m-p/2868295#M43914 Tejas Kunte 2019-03-10T13:37:16Z https://community.cisco.com/t5/network-security/firesight-simulation-mode/m-p/2868296#M43915 <P>Hello Tejas,</P> <P>Did you mean the monitor only mode ?</P> <P>Monitor only mode just sends a copy of the traffic and no actions will be taken on that traffic.</P> <P>Rate if this answer helps you.</P> <P>Regards</P> <P>Jetsy&nbsp;</P> Wed, 18 May 2016 18:21:57 GMT https://community.cisco.com/t5/network-security/firesight-simulation-mode/m-p/2868296#M43915 Jetsy Mathew 2016-05-18T18:21:57Z