topic Management interface stoped working after upgrade. in Network Security

Management interface stoped working after upgrade.

rexpetersen — Mon, 11 Mar 2019 23:23:01 GMT

After I have upgraded our ASA 5510 to 8.4.2 I have problem with the management interface.

Our former firmware 8.2.3 had no problem using the management interface as a DMZ zone, but after we upgraded to 8.4.2 we can't make it work.

The interface and the protocol is up, when I type: show interface.

But when I ping the interface from a computer connectet to the interface, nothing happens.

Even the logging shows nothing.

Anyone who can tell me what the problem can be ?

Best regards

Rex Petersen / Denmark

Management interface stoped working after upgrade.

Jennifer Halim — Tue, 26 Jun 2012 03:25:35 GMT

Do you have the command: "management-only" on that management interface?

If you do, please remove it and see if it works.

Management interface stoped working after upgrade.

rexpetersen — Tue, 26 Jun 2012 18:38:59 GMT

The management-only command has been removed.

I has been working before (8.2) but after upgrading to 8.4.2 it doesn't work.

// Rex

Management interface stoped working after upgrade.

Jennifer Halim — Wed, 27 Jun 2012 01:11:38 GMT

Can you please share your config?

I don't see any bugs related to management interface in version 8.4.2

Management interface stoped working after upgrade.

rexpetersen — Wed, 27 Jun 2012 07:00:11 GMT

I see, I was a little to fast at the keyboard.

It's version 8.4.3(9) and not verson 8.4.2.

// Rex

Management interface stoped working after upgrade.

Jennifer Halim — Wed, 27 Jun 2012 15:00:05 GMT

Sounds like a bug to me, you might want to open a TAC case to get it further troubleshot and open a new bug if it is one.

Re: Management interface stoped working after upgrade.

rexpetersen — Mon, 02 Jul 2012 09:18:30 GMT

Hi JeniferYesterday I testet on another ASA5510 with same firmware version, and everything was working ... strange.

Here the interface setup:

interface Ethernet0/0

nameif outside

security-level 0

ip address xx.xxx.xxx.x 255.255.255.224 standby xx.xxx.xxx.x

interface Ethernet0/1

nameif inside

security-level 100

ip address 10.34.4.246 255.255.248.0 standby 10.34.4.245

interface Ethernet0/2

nameif dmz

security-level 20

ip address 10.2.1.1 255.255.255.0

interface Ethernet0/3

description LAN Failover Interface

interface Management0/0

nameif dmz_1

security-level 25

ip address 10.3.1.1 255.255.255.0

boot system disk0:/asa843-k8.bin

Management interface stoped working after upgrade.

Jennifer Halim — Mon, 02 Jul 2012 14:04:19 GMT

Strange indeed.

Maybe try a reload and see if it makes any difference if you have the same on another ASA with same firmware and it works just fine.