topic Hi Abdul, in Network Security

IPS CPU utilization issue

Abdul moheed — Sun, 10 Mar 2019 13:29:06 GMT

Hi,

One of the active ssm-10 ips showing cpu utilization sometimes 100% and sometime 0%

is it normal or something else ?

Also find attachments

Hi Adbul,As i had mentioned

Akshay Rastogi — Wed, 21 Oct 2015 14:13:26 GMT

Hi Adbul,

As i had mentioned in earlier of your post, that cpu bar is not the correct indication of ips inspection load :

"CPU usage statistic are not a good indication of the sensor processing load. The inspection load percentage in the output of usage over last 5 sec 100 "

https://supportforums.cisco.com/discussion/12619366/ssm-10-signature-update-and-cpu-usage-issue

Rate if it helps!

Regards,

Akshay Rastogi

Thanks for your comments...

Abdul moheed — Sun, 25 Oct 2015 04:11:19 GMT

Thanks for your comments...

Then Whats the usage of CPU bar utilization there ?

Have you faced this issue earlier which shows inappropriate values ?

Is it bug for GUI ?

Hi Abdul,

Akshay Rastogi — Wed, 28 Oct 2015 15:06:47 GMT

Hi Abdul,

There has been one defect already addressing this behavior. another defect(an enhancement) has been opened which finally removed cpu bar statistics from GUI as it doesn't provide the correct behavior. Later versions have this enhacement.

Defect :

https://tools.cisco.com/bugsearch/bug/CSCtl74475/?reffering_site=dumpcr

Enhancement :

https://tools.cisco.com/bugsearch/bug/CSCub67598/?reffering_site=dumpcr

Regards,

Akshay Rastogi