topic Re: that did not work. I finally, in Network Security

Sourcefire Firepower: NTP setup

alphaomegait — Sun, 10 Mar 2019 13:16:24 GMT

I have run through the quick start guide and have the module up and running but can change the ntp setting from the cli while sessioned into the module.

Is it under expert or system modes?

On the old IPS I would just run setup again, so is there an option to do that?

Yes, you should be able to do

Marvin Rhoads — Sat, 01 Nov 2014 13:30:53 GMT

Yes, you should be able to do the following:

session sfr console

setup

The setup will prompt with defaults with what's already been setup and allow you to change from those values if you like.

that did not work. I finally,

alphaomegait — Mon, 03 Nov 2014 14:04:35 GMT

that did not work.

I finally, did it through firesight.

the documentation is a lot better.

quick start

http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/sfr/firepower-qsg.html

firepower

http://www.cisco.com/c/en/us/td/docs/security/asa/asa92/asdm72/firewall/asa-firewall-asdm/modules-sfr.pdf

firesight

http://www.cisco.com/c/dam/en/us/td/docs/security/firesight/531/PDFs/FireSIGHT-System-User-Guide-Version-5-3-1.pdf

Re: that did not work. I finally,

tonyk0001 — Wed, 09 May 2018 14:41:24 GMT

Hi Team.

Please note that I have the same issue.

Kindly find the attached options that I have in FMC advise.

Regards

Re: that did not work. I finally,

Marvin Rhoads — Fri, 11 May 2018 11:21:19 GMT

What is the issue - is your FMC not getting its time synchronized or are you trying (and failing) to use it as an NTP server for the managed devices?