Creating a simple static ip

par13 — Mon, 11 Mar 2019 22:46:22 GMT

Hello,

I have created a simple static ip address by using this command:

interface Vlan1

nameif inside

security-level 100

ip address 10.2.1.1 255.255.255.0

interface Vlan2

nameif outside

security-level 0

ip address 152.18.75.132 255.255.255.240

access-list outside_access_in extended permit ip any host 152.18.75.133

static (inside,outside) 152.18.75.133 10.2.1.2 netmask 255.255.255.255

access-group outside_access_in in interface outside

global (outside) 1 interface

nat (inside) 1 0.0.0.0 0.0.0.0

route outside 0.0.0.0 0.0.0.0 152.18.75.129 1

But, no matter what, the I can't ping the static address or access the computer 10.2.1.2 from outside of the asa 5505. I have attempted to ping from inside of the asa 5505 or from another computer. I just does not work.

I also have created several rules that allows icmp traffic.

icmp unreachable rate-limit 1 burst-size 1

icmp permit any echo-reply inside

icmp permit 10.2.1.0 255.255.255.0 inside

icmp permit any echo-reply outside

icmp permit any outside

What am I doing wrong?

Creating a simple static ip

Diego Armando Cambronero Arias — Wed, 28 Mar 2012 22:31:37 GMT

Did you enable ICMP inspection?

SInce this is a 5505 and you are using VLANs did you assigs the vlan to the switchport in the inside and outside?

topic Creating a simple static ip in Network Security

Creating a simple static ip

Creating a simple static ip