topic Remote Access - PIX 7.2(3) Issue in Network Security https://community.cisco.com/t5/network-security/remote-access-pix-7-2-3-issue/m-p/1003868#M493813 <P>Hi,</P><P></P><P>The tunnel connects and I am able to grab an IP address from the correct range. However, I am not able to pass traffic between the tunnel (192.168.5.0) and the DMZ interface/network (192.168.4.0).</P><P>What piece or pieces am I missing from my configuration?</P><P></P><P>I have attached the config.</P><P></P><P>thank you,</P><P>G</P><P></P><P></P><P></P><P> </P><P></P> Fri, 21 Feb 2020 10:00:50 GMT ciscows 2020-02-21T10:00:50Z Remote Access - PIX 7.2(3) Issue https://community.cisco.com/t5/network-security/remote-access-pix-7-2-3-issue/m-p/1003868#M493813 <P>Hi,</P><P></P><P>The tunnel connects and I am able to grab an IP address from the correct range. However, I am not able to pass traffic between the tunnel (192.168.5.0) and the DMZ interface/network (192.168.4.0).</P><P>What piece or pieces am I missing from my configuration?</P><P></P><P>I have attached the config.</P><P></P><P>thank you,</P><P>G</P><P></P><P></P><P></P><P> </P><P></P> Fri, 21 Feb 2020 10:00:50 GMT https://community.cisco.com/t5/network-security/remote-access-pix-7-2-3-issue/m-p/1003868#M493813 ciscows 2020-02-21T10:00:50Z Re: Remote Access - PIX 7.2(3) Issue https://community.cisco.com/t5/network-security/remote-access-pix-7-2-3-issue/m-p/1003869#M493820 <HTML><HEAD></HEAD><BODY><P>Please check your ACL it might be correction required.</P></BODY></HTML> Tue, 13 May 2008 18:00:47 GMT https://community.cisco.com/t5/network-security/remote-access-pix-7-2-3-issue/m-p/1003869#M493820 aghaznavi 2008-05-13T18:00:47Z Re: Remote Access - PIX 7.2(3) Issue https://community.cisco.com/t5/network-security/remote-access-pix-7-2-3-issue/m-p/1003870#M493825 <HTML><HEAD></HEAD><BODY><P>dmz nat exemption acl should be</P><P></P><P>access-list NamPix_DVC_nat0_outbound extended permit 192.168.4.0 255.255.255.0 192.168.5.0 255.255.255.0</P><P></P><P>Also, I don't think you need this route...</P><P></P><P>no route NamPix_DVC 192.168.5.0 255.255.255.0 192.168.4.1 1</P><P></P><P>You also have no group policy cdcvid defined.</P></BODY></HTML> Tue, 13 May 2008 18:09:40 GMT https://community.cisco.com/t5/network-security/remote-access-pix-7-2-3-issue/m-p/1003870#M493825 acomiskey 2008-05-13T18:09:40Z