topic ASA 5510 vlan in Network Security

ASA 5510 vlan

Jean-Francois Gagnon — Mon, 11 Mar 2019 21:42:59 GMT

Hi!

I need to be able to create vlans in my ASA 5510.

I can'T find anywhere to do this.

I've tried the "routers command" I know, like vlan databse and it does'nt work

Is there a way to "enable" vlan on a ASA 5510 ?

Thanks

Compiled on Fri 20-May-11 16:00 by builders

System image file is "disk0:/asa825-k8.bin"

Config file at boot was "startup-config"

ASA 5510 vlan

cadet alain — Wed, 26 Oct 2011 21:06:00 GMT

Hi,

just do like this:

int f0/0

interface f0/0.2

vlan 2

ip address x.x.x.x y.y.y.y

nameif xxx

security-level x

no sh

interface f0/0.3

vlan 3

ip address x.x.x.x y.y.y.y

nameif xxx

security-level x

no sh

Regards.

Alain.

Re: ASA 5510 vlan

Jean-Francois Gagnon — Mon, 31 Oct 2011 00:55:21 GMT

Thanks but I dont understand why the 5505 uses switchport commands...

Sent from Cisco Technical Support iPhone App

ASA 5510 vlan

Julio Carvajal — Mon, 31 Oct 2011 03:39:23 GMT

Hello Jean,

The way Cadet Alain said it is the way it should be configured on an ASA 5510.

So on ASA 5510 and higher plataforms each vlan that is carried over the trunk link terminates on a unique subinterface of a physical interface but on the ASA 5505 each vlan is defined by a unique vlan interface and can connect to physical interfaces and be carried over a vlan trunk link.

Hope this helps and if this answers all of your questions please mark the question as answered.

Regards,

Julio