topic Re: Configuring PIX 520 with 6 interfaces in Network Security

Configuring PIX 520 with 6 interfaces

3shoolgmail — Fri, 21 Feb 2020 08:56:33 GMT

Hi,

I request your help for below.

We have gotten two old PIX 520 firewalls in our office. We intend to do following:

1. Each firewall has 6 interfaces. 1st one would go for Internet. Can we configure remaining 5 interfaces for five different networks. These networks will be our public servers(public IP), hosted servers(public IP), leased network (private IP), head-office network (mixed IPs) and customer's DR network (public IP).

2. Can we configure VLANs on these six firewall interfaces.

3. How do we configure these two firewall in failover mode.

Please let me know whether we can achieve this. If yes, pls reply with some links or some documentation or commands.

We also have Cisco SUpport contract whether they would be able to run us through?

Thank you very much.

Re: Configuring PIX 520 with 6 interfaces

Fernando_Meza — Fri, 02 Jun 2006 01:58:52 GMT

HI .. in reagrds to your questions. I believe you must be using a PIX 525 correct ..?

1.- Yes you can. You can also configure VLANs. For doing that you will have to use one physical interface as trunk to your switch ( where the VLANs are configured ) and then you can bind Vlan interfaces accrodingly.

2.- Yes .. as mentioned above.

3.- The link below will help you configurating what you need. I suggest you install version 7.X

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008054c4b7.html

I hope it helps ... please rate it if it does !!!

Re: Configuring PIX 520 with 6 interfaces

3shoolgmail — Fri, 02 Jun 2006 14:59:12 GMT

Hi Fernando,

No, I'm using PIX 520 and it does not support version 7.x.

Does this firewall support VLANs inbuilt or I must have a layer 3 switch to configure VLANs?

Thanks.