topic rsa key pix 8 in Network Security https://community.cisco.com/t5/network-security/rsa-key-pix-8/m-p/1445248#M502775 <P>After I reload the PIX 515 with version 8.0(4)31 <BR />I checked the rsa key, it's not there. <BR />I generated my key "crypto key generate rsa modulus 1024" again <BR />save it using "write mem" and then reload, <BR />it disappear after reload. Is it the right behavior?</P><P><BR />Thanks for any reply.</P> Fri, 21 Feb 2020 12:00:44 GMT sidneyhenry12 2020-02-21T12:00:44Z rsa key pix 8 https://community.cisco.com/t5/network-security/rsa-key-pix-8/m-p/1445248#M502775 <P>After I reload the PIX 515 with version 8.0(4)31 <BR />I checked the rsa key, it's not there. <BR />I generated my key "crypto key generate rsa modulus 1024" again <BR />save it using "write mem" and then reload, <BR />it disappear after reload. Is it the right behavior?</P><P><BR />Thanks for any reply.</P> Fri, 21 Feb 2020 12:00:44 GMT https://community.cisco.com/t5/network-security/rsa-key-pix-8/m-p/1445248#M502775 sidneyhenry12 2020-02-21T12:00:44Z Re: rsa key pix 8 https://community.cisco.com/t5/network-security/rsa-key-pix-8/m-p/1445249#M502776 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P></P><P>The&nbsp; crypto config key is not seen if you issue show run&nbsp; or show start if that is what you meant in your post, the key should still be there ,&nbsp; the show crypto key command syntax&nbsp; bellow should provide details of your configured crypto key and modulus size etc.., or is it your case that no output is seen when you issue&nbsp; the command bellow?</P><P></P><P>#show crypto key mypubkey rsa</P><P></P><P></P><P>HTH</P><P>Regards</P></BODY></HTML> Mon, 05 Jul 2010 16:12:31 GMT https://community.cisco.com/t5/network-security/rsa-key-pix-8/m-p/1445249#M502776 JORGE RODRIGUEZ 2010-07-05T16:12:31Z