topic PIX 515E in Network Security https://community.cisco.com/t5/network-security/pix-515e/m-p/553378#M527021 <P>We currently are running on a PIX 515 version 5.2(3) and need to upgrade to a 515E. When I duplicate the configuration to the new system I cannot access the DMZ zone. Everything else works. Any ideas?</P><P>Thanks</P><P></P><P>We are running version 7.0 on the 515E </P> Fri, 21 Feb 2020 08:44:46 GMT gottchilds 2020-02-21T08:44:46Z PIX 515E https://community.cisco.com/t5/network-security/pix-515e/m-p/553378#M527021 <P>We currently are running on a PIX 515 version 5.2(3) and need to upgrade to a 515E. When I duplicate the configuration to the new system I cannot access the DMZ zone. Everything else works. Any ideas?</P><P>Thanks</P><P></P><P>We are running version 7.0 on the 515E </P> Fri, 21 Feb 2020 08:44:46 GMT https://community.cisco.com/t5/network-security/pix-515e/m-p/553378#M527021 gottchilds 2020-02-21T08:44:46Z Re: PIX 515E https://community.cisco.com/t5/network-security/pix-515e/m-p/553379#M527022 <HTML><HEAD></HEAD><BODY><P>Add nonat config for the DMZ interface. For example, assume this configuration:</P><P></P><P>ip address inside 10.1.1.1 255.255.255.0</P><P>ip address dmz 172.16.1.1 255.255.255.0</P><P>ip local pool vpn_pool 192.168.1.1-192.168.1.254</P><P>access-list split_tunnel permit ip 10.1.1.0 255.255.255.0 192.168.1.0 255.255.255.0</P><P>nat (inside) 0 access-list split_tunnel</P><P>Enter these commands:</P><P></P><P>access-list split_tunnel permit ip 172.16.1.0 255.255.255.0 192.168.1.0 255.255.255.0</P><P></P><P>nat (dmz) 0 access-list split_tunnel </P></BODY></HTML> Tue, 07 Mar 2006 19:40:25 GMT https://community.cisco.com/t5/network-security/pix-515e/m-p/553379#M527022 owillins 2006-03-07T19:40:25Z