topic Re: PIX Lab setup in Network Security https://community.cisco.com/t5/network-security/pix-lab-setup/m-p/485924#M532124 <HTML><HEAD></HEAD><BODY><P>yes mate that would work fine, although you could just put the inside pc directly to the pix as well and bypass the layer 2 switch...</P></BODY></HTML> Sat, 08 Oct 2005 20:23:29 GMT itchampnz 2005-10-08T20:23:29Z PIX Lab setup https://community.cisco.com/t5/network-security/pix-lab-setup/m-p/485923#M532123 <P>Hi...</P><P></P><P>I have apix 515 FW with DES enabled. I want to set it up to test VPN. I have a 2950 at hand and I was wondering if the right setup is to connect the pix outside interface to a pc with vpn client and the inside to the switch where another host is connected, then try to access this host using the vpn client. </P><P></P><P>I just want to make sure this is the right way before starting the setup.</P><P></P><P>Thanks...</P> Fri, 21 Feb 2020 08:27:02 GMT https://community.cisco.com/t5/network-security/pix-lab-setup/m-p/485923#M532123 mo shea 2020-02-21T08:27:02Z Re: PIX Lab setup https://community.cisco.com/t5/network-security/pix-lab-setup/m-p/485924#M532124 <HTML><HEAD></HEAD><BODY><P>yes mate that would work fine, although you could just put the inside pc directly to the pix as well and bypass the layer 2 switch...</P></BODY></HTML> Sat, 08 Oct 2005 20:23:29 GMT https://community.cisco.com/t5/network-security/pix-lab-setup/m-p/485924#M532124 itchampnz 2005-10-08T20:23:29Z