PIX 515 running 6.2(1) code - advice/help needed.

OHITS-OPS — Fri, 21 Feb 2020 08:19:54 GMT

I have setup VPN client access to my PIX 515 running version 6.2 (1), now my problem is as follows:

When I use a PSTN dial-up connection from my laptop and then run the VPN client, I can connect to my PIX – no problem and also can access the internal network. But when I try to connect to the PIX using the same VPN client from behind another PIX (running version 6.3(4)) I can not connect, I get a ‘peer not responding message on the VPN client’.

Can someone please explain what I am missing here, or do I need to enable some command on the PIX which is running 6.2(1) code??

I have NAT-T enabled on my PIX with 6.3(4) code but can not find any references to NAT-T for PIX with 6.2(1) code!! – could this be the problem, if so is there any solutions?

PS. I am using VPN client version 4.0.1 (Rel)

I really need this up and running ASAP so any help will be much appreciated also, I can not upgrade the 515 to 6.3(4) as customer does not want to!!!

Many thanks for you assistance.

Re: PIX 515 running 6.2(1) code - advice/help needed.

froggy3132000 — Mon, 15 Aug 2005 17:45:13 GMT

enter in this command:

nat-traversal

After you upgrade your code.

topic PIX 515 running 6.2(1) code - advice/help needed. in Network Security

PIX 515 running 6.2(1) code - advice/help needed.

Re: PIX 515 running 6.2(1) code - advice/help needed.