topic ECLB for IPS in Network Security https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980124#M55099 <P>I have gone through following document </P><P></P><P><A href="http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/eclbips5.htm" target="_blank">http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/eclbips5.htm</A></P><P></P><P>and I wanted to know if I can configure ECLB with 2 IPS appliances and a 4500 switch ? The document states it can be done with 6500 but that is for the service module option .</P> Sun, 10 Mar 2019 12:42:25 GMT communication.boy 2019-03-10T12:42:25Z ECLB for IPS https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980124#M55099 <P>I have gone through following document </P><P></P><P><A href="http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/eclbips5.htm" target="_blank">http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/eclbips5.htm</A></P><P></P><P>and I wanted to know if I can configure ECLB with 2 IPS appliances and a 4500 switch ? The document states it can be done with 6500 but that is for the service module option .</P> Sun, 10 Mar 2019 12:42:25 GMT https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980124#M55099 communication.boy 2019-03-10T12:42:25Z ECLB for IPS https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980125#M55100 <HTML><HEAD></HEAD><BODY><P>anyone ?</P></BODY></HTML> Wed, 27 Jun 2012 12:38:19 GMT https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980125#M55100 communication.boy 2012-06-27T12:38:19Z ECLB for IPS https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980126#M55101 <HTML><HEAD></HEAD><BODY><P>Hi, </P><P></P><P>As far it goes, it only will support it for high availability and not for traffic divert. The other option woluld be an ASA in transparent ending up an ehterchannel there. </P><P></P><P>Mike</P></BODY></HTML> Tue, 10 Jul 2012 07:10:25 GMT https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980126#M55101 Maykol Rojas 2012-07-10T07:10:25Z ECLB for IPS https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980127#M55102 <HTML><HEAD></HEAD><BODY><P>Any properly performed STATEFULL load balancing can be used to spread traffic lad across multiple sensors. ECLB works. Since the load balancing decision is being made for each source/dest IP address pair you will find it wont evenly balance your load 50/50. It will be close, but don;t be surprised (or plan for) 60/40 or worse, depending on your traffic.</P><P></P><P>- Bob</P></BODY></HTML> Tue, 31 Jul 2012 22:01:57 GMT https://community.cisco.com/t5/network-security/eclb-for-ips/m-p/1980127#M55102 rhermes 2012-07-31T22:01:57Z