topic upgrade asa5585x ips in Network Security

upgrade asa5585x ips

JMCNEL — Sun, 10 Mar 2019 12:38:30 GMT

I upgraded our IPS from 7.1(3)E4 to 7.1(4)E4. My question is how long does it normally take to reboot?

upgrade asa5585x ips

sawgupta — Fri, 16 Mar 2012 03:38:59 GMT

Hi,

Is the IPS box not responding ?

Any erros that you saw while upgrading ?

Regards,

Sawan Gupta

upgrade asa5585x ips

JMCNEL — Fri, 16 Mar 2012 12:27:51 GMT

- performed the upgrade using the CLI with no errors

- The upgrade process appeared to complete and reboot, however, the module never came back

to an up state

- sh module 1 detail showed the SSP in an unresponsive state

- sh tech does not show much of anything in the main.log

only message observed during the post is

Cid/E errSystemError - collectStatistics
failed: System error: Could not get user mode interface statistics
[IntfcManager::IntfcManager]

- Most likely related to CSCtw62226

upgrade asa5585x ips

sawgupta — Fri, 16 Mar 2012 13:12:27 GMT

"sh module 1 detail showed the SSP in an unresponsive state", however you are able to connect to SSP and collect show tech, so module is responding ?

So the issue is that, that it is showing "Unresponsive" state ? Is it possible to do a reset on the module ?

The error message above can be seen when Analysis Engine is little busy.

Regards,

Sawan Gupta

upgrade asa5585x ips

JMCNEL — Fri, 16 Mar 2012 13:59:28 GMT

I can not ping the IPS, so I logged into the ASA and did a sh module 1 detail - which showed it was unresponsive - then I did a hw-module module 1 reset. then after about 10 minutes it came back and i could get the sh tech details.