topic Cant execute show command via ssh to IPS module in Network Security

Cant execute show command via ssh to IPS module

pemasirid — Sun, 10 Mar 2019 12:35:59 GMT

Hi,

We having two IPS ssm module with version 7.0(3)E3, we can access the IPS via SSH but we can not give any command except show version. When we give other commands it gets hang. Moreover we can not access it thorugh IDM/ASDM even.

But we can give all show command when we access via sessioning from ASA. ???

Regards

Cant execute show command via ssh to IPS module

rhermes — Mon, 30 Jan 2012 16:39:47 GMT

If you have not tried rebooting the sensor yet, you should try that now.

If that doesn't help, you can reimage it.

- Bob

Cant execute show command via ssh to IPS module

integreon — Mon, 30 Jan 2012 19:08:46 GMT

hw-module module 1 reload

Cant execute show command via ssh to IPS module

pemasirid — Mon, 30 Jan 2012 20:05:17 GMT

Hi Bob,

Thanks for your time and reply on this. Yes we did couple of time reboot but no success. We didnt think of software upgrad/re-image because we can access it when we session from ASA.?

Is there any other workaround before we go for upgrade.?

Cant execute show command via ssh to IPS module

pemasirid — Mon, 30 Jan 2012 20:05:52 GMT

hi Integreon,

Thanks we did this but stil the same issue..?

Cant execute show command via ssh to IPS module

integreon — Mon, 30 Jan 2012 20:16:39 GMT

Are you running 7.0(3)E3 or 7.0(3)E4 version? I do not see any 7.0(3)E3 version in cisco software download. Did you do any upgrade from E3 to E4? If yes, i would recommend you to downgrade this to 7.0(2)E3. You can perfrom this in your secondary box by not tampering your production.

Cant execute show command via ssh to IPS module

rhermes — Mon, 30 Jan 2012 21:28:57 GMT

Your module has a problem. You want to determine if it's a hardware or software problem.

Most likely this is a software issue, but to prove it, you need to re-image your sensor. You don;t have to upgrade your software, you can re-install the same image.You can also back up your current config into a text file and paste it back in.

- Bob

Cant execute show command via ssh to IPS module

rhermes — Mon, 30 Jan 2012 21:30:22 GMT

He needs to run E4 in order to update the signatures on that module.

Cant execute show command via ssh to IPS module

integreon — Mon, 30 Jan 2012 21:50:03 GMT

My apologies. You are right Rhermes.

Pemasirid, What is your current version. Can you upgrade it to 7.0(5a)E4 on the secondary box?

Regards,

Anton