topic PIX blocks Windows Server 2003 EDNS0(DNS) replies. in Network Security

PIX blocks Windows Server 2003 EDNS0(DNS) replies.

swbruce21 — Fri, 21 Feb 2020 08:07:05 GMT

PIX Firewall earlier than version 6.3(2) block dns query responses if query comes from Server 2003 and the external DNS server supports EDNSO. Microsoft's workaround of disabling DNS-Probes did not solve the problem. Short of updating the IOS is there a way to change the DNS-UDP packet size limit that is currently set on PIX? . . or some other solution ?

Re: PIX blocks Windows Server 2003 EDNS0(DNS) replies.

mhussein — Sun, 01 May 2005 17:34:20 GMT

In PIX OS 6.3, it is possible to change the maximum DNS packet length using "fixup protocol" command:

fixup protocol dns maximum-length

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a8.html#wp1067379

Or disabling dns fixup altogether (no fixup protocol dns)

I don't think there is any workaround with OS 6.2 and earlier, since the "DNS Guard" feature is hard-coded with no knobs for tweaking.

These threads are related to the same issue:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Firewalling&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd75208

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Firewalling&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd7c059

HTH,

Mustafa

Re: PIX blocks Windows Server 2003 EDNS0(DNS) replies.

sweaver — Mon, 02 May 2005 13:34:36 GMT

I had the same problem and resolved it back in November using this procedure. Make sure you do it on BDC also. Stop/Restart DNS service or reboot domain controllers.

For those customers using the Microsoft Windows 2003 Server's DNS

application, you must first install the dnscmd.exe command-line tool

from the Microsft Windows 2003 Server CD-ROM's Support Tools. Once

this is installed, open a DOS command prompt window and type:

dnscmd /config /enableednsprobes 0

This will turn off EDNS.

If at a future time the customer upgrades their firewall application

to support EDNS, running "dnscmd /config /enableednsprobes 1" will

turn EDNS back on.

Re: PIX blocks Windows Server 2003 EDNS0(DNS) replies.

swbruce21 — Mon, 02 May 2005 18:00:48 GMT

Thanks, I mentioned in my question that I had disabled dns probes. I found some newsgroups that indicated that in some case the problem would persist as it had in mine. I am glad it solve your problem.

Re: PIX blocks Windows Server 2003 EDNS0(DNS) replies.

swbruce21 — Mon, 02 May 2005 18:17:16 GMT

Thank You - very helpful