topic command reference for IPS7 in Network Security

command reference for IPS7

mlopacinski — Sun, 10 Mar 2019 12:32:48 GMT

Hello

When can i find command reference for IPS appliance ?

i've found this link:

but these are only system commands. I need all commans including signature/engine configuration.

For example: "specify-src-addr-filter"

Where can i find it ? (IOS IPS have much fever commands than IPS7)

Thanx

rhermes — Tue, 22 Nov 2011 23:07:02 GMT

You're on the right track, a lot of the IPS sensor's configuration commands are under the "service" command.

- Bob

mlopacinski — Wed, 23 Nov 2011 06:45:56 GMT

Yes, but those commands are not documented. Its not just few commands but about 100 or more. Why ?

Example:

specify-src-addr-filter

user-profiles

never-block-hosts

never-block-networks

communication

trap-destinations

enable-set-get

ip-reassembly-mode

tcp-reassembly-mode

It's just few examples. Do you know where can i find command reference with the above commands ?

Thanx

rhermes — Wed, 23 Nov 2011 16:43:53 GMT

Sorry for the regurgitated reference, I think this is more of what you were looking for:

- Bob

mlopacinski — Wed, 23 Nov 2011 16:55:54 GMT

I know configuration guide, it's quite good, but it's not command reference. And because of this it's not complete.

I used wget&&grep and did not find this commands:

ip-reassembly-mode

specify-src-addr-filter

Did you ?

I could find MANY more commands which are not in configuration guide (and command reference too).

Why cisco could not make a decent command reference for IPS ?

Thanx