topic Re: OCC Tool Question in Network Security

OCC Tool Question

Thomas Reiling — Mon, 11 Mar 2019 20:13:46 GMT

I'm trying to use the Outbound/Conduit Converstion tool they way it reads in the Migration Guide. I use the following command at the command prompt:

occ old_config new_config

I get nothing. I have my old config in the same directory as the occ.exe file. Am I missing something?

Thank you,

Thomas

csaxena — Tue, 29 Mar 2011 15:17:57 GMT

Hello Thomas,

Here is a link which expains use of conversion tool :

Another good link which you can refer for use of GUI/CLI:

(Converting a Cisco PIX Configuration to a Cisco ASA 5500 Series Configuration Section)

Hope this helps. Please reply back if you need any further assistance.

Regards,
Chirag
P.S.: Please mark this thread as answered if you feel your query is answered. Do rate helpful posts.

patrick.crum — Fri, 01 Apr 2011 04:49:43 GMT

Try to run the bare bone command of occ.exe filename and nothing else. I couldnt get it to work by doing the recommended. Occ file1 output dilename

Sent from Cisco Technical Support iPhone App

Thomas Reiling — Fri, 01 Apr 2011 21:34:53 GMT

I figured it out. I was not putting in the ">" character between the two file names.

csaxena — Sat, 02 Apr 2011 00:15:06 GMT

Glad it is working now. Please mark this post answered for others to refer in future.

Regards,

Chirag

ekwasny — Fri, 22 Apr 2011 15:19:33 GMT

Thank youy so much. Yes, you have to put a ">" between the input and output file names.

How long will this go on before Cisco desides to add the change to the Migration Guide.....

Thanks Again..... EDK

csaxena — Sat, 23 Apr 2011 06:36:05 GMT

Thanks EDK for bring it to our notice. I shall forward the info the Business Unit for the same.

Regards,
Chirag