https://community.cisco.com/t5/network-security/enabling-ping-for-dmz/m-p/1612286#M564274 <HTML><HEAD></HEAD><BODY><P>Just add an acl on the outside interface allowing icmp from any to the public ip of the servers.</P><P></P><P>Sent from Cisco Technical Support iPhone App</P></BODY></HTML> Sat, 05 Mar 2011 20:58:22 GMT PAUL GILBERT ARIAS 2011-03-05T20:58:22Z https://community.cisco.com/t5/network-security/enabling-ping-for-dmz/m-p/1612285#M564270 <P>I currently have an ASA 5510 unit. I have a dmz setup which house some web servers and an inside interface. The web servers contain multiple public ip addresses which I have natted and access is fine.</P><P></P><P>What is the most simple way to enable ping for my dmz from the outside. Meaning if someone outside the network pings one of the servers by its public ip address I would like it to respond to ping. Hope I explained this well any help is greatly appreciated.</P><P></P><P></P><P>Thanks,</P><P>Kevin</P> Mon, 11 Mar 2019 20:01:23 GMT https://community.cisco.com/t5/network-security/enabling-ping-for-dmz/m-p/1612285#M564270 ksuber0758 2019-03-11T20:01:23Z https://community.cisco.com/t5/network-security/enabling-ping-for-dmz/m-p/1612286#M564274 <HTML><HEAD></HEAD><BODY><P>Just add an acl on the outside interface allowing icmp from any to the public ip of the servers.</P><P></P><P>Sent from Cisco Technical Support iPhone App</P></BODY></HTML> Sat, 05 Mar 2011 20:58:22 GMT https://community.cisco.com/t5/network-security/enabling-ping-for-dmz/m-p/1612286#M564274 PAUL GILBERT ARIAS 2011-03-05T20:58:22Z