topic Re: pix 506E simple question in Network Security

pix 506E simple question

sysadmin — Fri, 21 Feb 2020 06:59:37 GMT

Hi,

Im stuck on a little problem. I'm setting up a brand new 506E firewall. When I try to specify an internal IP for my interface I get the following error, "interface address is not on the same subnet as the dhcp pool" I've disbaled the DHCP server on the firewall, but it still gives me that error. The second thing when I load the PDM version 3.0.1 under device information license it says not applicable, is there something I need to do to enable the license??

Any help would be greatly appreciated.

Thanks

Re: pix 506E simple question

jmia — Mon, 15 Sep 2003 16:24:13 GMT

Hello -

Please check this document for a quick start up giude to PIX 506E - This document is a PDF.

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_62/qsg/506quick.pdf

Hope it helps - Thanks Jay.

Re: pix 506E simple question

apriore685 — Mon, 15 Sep 2003 16:40:56 GMT

What I always do with the pix 501 and 506 is to do a write erase and start fresh.

Re: pix 506E simple question

bhillman — Tue, 16 Sep 2003 01:21:46 GMT

PDM requres at least DES key be installed. I concur withh the others. I ALWAYS do write erase and reload then start with my config. I also never use the script.

Re: pix 506E simple question

sysadmin — Tue, 16 Sep 2003 19:55:53 GMT

Great thanks guys, I guess i'll erase my config. What about the license part in PDM? It says it’s not applicable, will that cause me any problems?