topic Re: PIX and ROUTE in Network Security

PIX and ROUTE

ah_shaban — Fri, 21 Feb 2020 07:26:04 GMT

what is the best routing design for pix 501 have two interface inside & outside and what is the command

for os 6.3

Re: PIX and ROUTE

ehirsel — Wed, 02 Jun 2004 10:12:27 GMT

Using static routes would be the best, unless you have a router off of the inside and/or outside interfaces that has/have a need to exhange routes with the pix. The pix would have these statements:

route outside 0.0.0.0 0.0.0.0 gw-address

route inside 10.0.0.0 255.0.0.0 internal-gw-address

If there are no routers on the inside, then the route inside statement is not needed.

This assumes that you have a valid static outside/public ip address allocated for you to use. If your pix will get a dynamic address, then go to www.cisco.com and exmaine the pix 6.3 doc to get the details on configuring the pix as a dhcp or a PPPoE client.

Re: PIX and ROUTE

ah_shaban — Thu, 03 Jun 2004 06:20:38 GMT

My Pix has two interfaces

the outside conected to the router

and the inside conected to the Main HUB

so is command above ir right

I want use a static route