topic Re: Disabling PIX Interfaces... in Network Security https://community.cisco.com/t5/network-security/disabling-pix-interfaces/m-p/285838#M594528 <HTML><HEAD></HEAD><BODY><P>there shouldn't be a problem - I am 99% certain that pixen disable all interfaces by default (or at least the non-inside ones), so that there are probably not commands because there have not been ones manually added, and thus they are still shutdown. What do you see on a show interface - if interface xxx is down, then it is down (line protocol up/down refers to whether there is a worknig cable plugged into it)</P></BODY></HTML> Tue, 17 Feb 2004 16:18:05 GMT mostiguy 2004-02-17T16:18:05Z Disabling PIX Interfaces... https://community.cisco.com/t5/network-security/disabling-pix-interfaces/m-p/285837#M594520 <P>I am reviewing a PIX configuration where two interfaces do not have IP addresses assigned to them ("no ip address"), but the interfaces have not been disabled using the "shutdown" keyword. Are there exposures in this instance due to the fact that the interfaces have not been "shutdown"?</P><P></P><P>Thank you.</P><P></P> Fri, 21 Feb 2020 07:14:45 GMT https://community.cisco.com/t5/network-security/disabling-pix-interfaces/m-p/285837#M594520 rvaccare 2020-02-21T07:14:45Z Re: Disabling PIX Interfaces... https://community.cisco.com/t5/network-security/disabling-pix-interfaces/m-p/285838#M594528 <HTML><HEAD></HEAD><BODY><P>there shouldn't be a problem - I am 99% certain that pixen disable all interfaces by default (or at least the non-inside ones), so that there are probably not commands because there have not been ones manually added, and thus they are still shutdown. What do you see on a show interface - if interface xxx is down, then it is down (line protocol up/down refers to whether there is a worknig cable plugged into it)</P></BODY></HTML> Tue, 17 Feb 2004 16:18:05 GMT https://community.cisco.com/t5/network-security/disabling-pix-interfaces/m-p/285838#M594528 mostiguy 2004-02-17T16:18:05Z