topic Re: secondary fwsm in Network Security

secondary fwsm

m.ancheta — Mon, 11 Mar 2019 18:38:40 GMT

when sessioned to the secondary fwsm version 2.3.4, is it normal not to see ip addresses when doing a "show ip" besides 127.0.0.81 and the failoverlink ip?

Re: secondary fwsm

mirober2 — Fri, 10 Sep 2010 16:02:26 GMT

Hello,

It sounds like you don't have standby IP addresses configured for the interfaces. You can do this with the following command under the interface config:

ip address standby

When you configure those, you should see them listed in the 'show ip address' output.

Hope that helps.

-Mike

Re: secondary fwsm

m.ancheta — Fri, 10 Sep 2010 16:17:21 GMT

I have all my ip address showing in the primary

System IP Addresses

           ip address eobc 127.0.0.81 255.255.255.0
        ip address inside 10.254.15.4 255.255.255.248
        ip address WiFi-Proxydmz 10.254.50.5 255.255.255.0
        ip address enterprisedmz 10.254.15.17 255.255.255.248
        ip address fimsdmz 10.254.36.1 255.255.255.0
        ip address failoverdmz 10.254.15.9 255.255.255.248

but if i am on the secondary, i only see:

System IP Addresses:
        ip address eobc 127.0.0.81 255.255.255.0
        ip address failoverdmz 10.254.15.9 255.255.255.248
Current IP Addresses:
        ip address eobc 127.0.0.81 255.255.255.0
        ip address failoverdmz 10.254.15.10 255.255.255.248

All my failover commands for secondary unit are in there.

Re: secondary fwsm

mirober2 — Fri, 10 Sep 2010 16:49:05 GMT

Hi Manny,

Looks like we have a TAC case open for this together as well : ) Let's troubleshoot under the TAC case and we can post the answer for the rest of the folks once we get it solved.

-Mike