topic Monitor PIX Failover in Network Security https://community.cisco.com/t5/network-security/monitor-pix-failover/m-p/153917#M615708 <P>hallo all,</P><P></P><P>i run two pix 535 in failover mode. one primary pix in active mode and a secundary pix in standby mode.</P><P>can i monitor, perhaps per snmp, when the pix switches from active in secundary mode ?</P><P></P><P>thanks in advance . . .</P> Fri, 21 Feb 2020 06:51:23 GMT mklimesch 2020-02-21T06:51:23Z Monitor PIX Failover https://community.cisco.com/t5/network-security/monitor-pix-failover/m-p/153917#M615708 <P>hallo all,</P><P></P><P>i run two pix 535 in failover mode. one primary pix in active mode and a secundary pix in standby mode.</P><P>can i monitor, perhaps per snmp, when the pix switches from active in secundary mode ?</P><P></P><P>thanks in advance . . .</P> Fri, 21 Feb 2020 06:51:23 GMT https://community.cisco.com/t5/network-security/monitor-pix-failover/m-p/153917#M615708 mklimesch 2020-02-21T06:51:23Z Re: Monitor PIX Failover https://community.cisco.com/t5/network-security/monitor-pix-failover/m-p/153918#M615709 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P>Failover messages always have a syslog priority level of 2, which indicates a critical condition. To receive SNMP syslog traps (SNMP failover traps), you must configure the SNMP agent to send SNMP traps to SNMP management stations, define a syslog host, and also have compiled the Cisco syslog MIB into your SNMP management station. </P><P>For more info on SNMP, refer to this url;</P><P><A class="jive-link-custom" href="http://www.cisco.com/en/US/partner/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a008008996b.html#xtocid24" target="_blank">http://www.cisco.com/en/US/partner/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a008008996b.html#xtocid24</A></P><P></P><P>Yatin</P><P></P></BODY></HTML> Tue, 15 Jul 2003 12:49:47 GMT https://community.cisco.com/t5/network-security/monitor-pix-failover/m-p/153918#M615709 ywadhavk 2003-07-15T12:49:47Z