https://community.cisco.com/t5/network-security/pix-515-access-list-problems/m-p/25803#M644887 <P>Can anyone tell me what would cause this message to display when we reboot our PIX 515.</P><P></P><P>WARNING: access-list protocol or port will not be used</P><P></P><P>This is warning is displayed in the last line of the start up routine.</P><P></P><P>Could a setting in the configuration be stopping the access-list protocol from working?</P><P></P><P>Thanks.</P><P></P> Fri, 21 Feb 2020 06:05:16 GMT jgrosche 2020-02-21T06:05:16Z https://community.cisco.com/t5/network-security/pix-515-access-list-problems/m-p/25803#M644887 <P>Can anyone tell me what would cause this message to display when we reboot our PIX 515.</P><P></P><P>WARNING: access-list protocol or port will not be used</P><P></P><P>This is warning is displayed in the last line of the start up routine.</P><P></P><P>Could a setting in the configuration be stopping the access-list protocol from working?</P><P></P><P>Thanks.</P><P></P> Fri, 21 Feb 2020 06:05:16 GMT https://community.cisco.com/t5/network-security/pix-515-access-list-problems/m-p/25803#M644887 jgrosche 2020-02-21T06:05:16Z https://community.cisco.com/t5/network-security/pix-515-access-list-problems/m-p/25804#M644888 <HTML><HEAD></HEAD><BODY><P>i guess you are using PIX 6.2 code and have Reverse NAT configured, with something as follows</P><P>nat (outside) 2 access-list abc</P><P>or</P><P>nat (outside) 1 access-list abc</P><P></P><P>NAT access-list only works with nat 0.</P><P></P><P>Hope that helps</P><P></P><P>R/Yusuf</P></BODY></HTML> Fri, 07 Jun 2002 09:52:18 GMT https://community.cisco.com/t5/network-security/pix-515-access-list-problems/m-p/25804#M644888 yusuff 2002-06-07T09:52:18Z