topic Re: Pix and Checkpoint client in Network Security https://community.cisco.com/t5/network-security/pix-and-checkpoint-client/m-p/92244#M647477 <HTML><HEAD></HEAD><BODY><P>Translation creation failed indicates a problem with the NAT static or global pool. Take a look at why the host is not getting a translation. If you&#146;re sure the configuration is correct, save your config to flash and reboot before you test again. </P></BODY></HTML> Wed, 13 Feb 2002 19:17:32 GMT j-block 2002-02-13T19:17:32Z Pix and Checkpoint client https://community.cisco.com/t5/network-security/pix-and-checkpoint-client/m-p/92243#M647429 <P>Have Secureclient on workstation inside network trying to access a Checkpoint firewall through a PIX 515. I authenticate to Checkpoint firewall, but then cannot hit protected website. I've opened outside access list to esp protocol and port 500. Get error message Pix-3-305006: Regular translation creation failed for protocol 50 src 172.1.31.19 dst 208.129.19.194. Anyone run across this?</P> Fri, 21 Feb 2020 05:58:32 GMT https://community.cisco.com/t5/network-security/pix-and-checkpoint-client/m-p/92243#M647429 ktoalson 2020-02-21T05:58:32Z Re: Pix and Checkpoint client https://community.cisco.com/t5/network-security/pix-and-checkpoint-client/m-p/92244#M647477 <HTML><HEAD></HEAD><BODY><P>Translation creation failed indicates a problem with the NAT static or global pool. Take a look at why the host is not getting a translation. If you&#146;re sure the configuration is correct, save your config to flash and reboot before you test again. </P></BODY></HTML> Wed, 13 Feb 2002 19:17:32 GMT https://community.cisco.com/t5/network-security/pix-and-checkpoint-client/m-p/92244#M647477 j-block 2002-02-13T19:17:32Z