topic Re: Sig Update Error in Network Security

Sig Update Error

quintin.hassell — Sun, 10 Mar 2019 12:17:25 GMT

I'm getting the following error when

attempting to upgrade the signature file on a SSM-20:

"Cannot parse the current config for the component signature definition instance sig0"

Re: Sig Update Error

michael.clark — Mon, 07 Mar 2011 11:40:46 GMT

I am getting this exact same error when attempting to update signatures on our IDSM-2 modules.

This has happened on the last two signature definitions, S550 & S551, our IDSM-2 engine version is 7.0(2)E4.

Does anyone have a quick fix for this before I raise the issue in a TAC case?

Cheers

Re: Sig Update Error

quintin.hassell — Mon, 07 Mar 2011 19:59:18 GMT

I have the same engine version as you do. I have a TAC case open.

They had me reboot my module. Didn't fix it. I'll let you know if they come up with a solution for me.

Re: Sig Update Error

benreynolds — Thu, 10 Mar 2011 12:29:26 GMT

We are getting the same issue accross the board with our AIP-SSM cards.

Looks like restoring default sig values then manually updating works. Bit of a pain as we have over 35 units to complete this on.....

Just hope it's not a regular thing .

Re: Sig Update Error

quintin.hassell — Thu, 10 Mar 2011 14:12:27 GMT

Saving your current config and defaulting the sigs, then restoring will work. Also I was advised to try defaulting sig 23899/0 and then trying the update. I'm going to try that tonight to see if it works.

Sig Update Error

Aibek197938 — Tue, 10 Apr 2012 10:43:55 GMT

Signature update S567 has the permanent fix for the issue. Update to S567 (or later) to correct the issue. Reset 23899.0 to its default settings prior to updating.

Change signature 23899.0 to the default settings, for example:

# conf t

(config)# service signature-definition sig0

(config-sig)# default signatures 23899 0

(config-sig)# exit

(config)# exit