topic Re: FWSM.2.3 (Packet-Tracer) in Network Security https://community.cisco.com/t5/network-security/fwsm-2-3-packet-tracer/m-p/1474407#M663379 <HTML><HEAD></HEAD><BODY><P>Packet Tracer is not available to FWSM codes at the moment.</P><P></P><P>There is no simulation type commands that you can use with the FWSM code at the moment. You wqill have to test with real traffic, and check logs or do packet captures, to check for results.</P><P></P><P>Regards,</P></BODY></HTML> Thu, 10 Jun 2010 23:17:50 GMT edadios 2010-06-10T23:17:50Z FWSM.2.3 (Packet-Tracer) https://community.cisco.com/t5/network-security/fwsm-2-3-packet-tracer/m-p/1474406#M663356 <P>Hi All,</P><P></P><P>I've been trying to figure the syntax for a "packet-tracer" like command for FWSM 2.3. Does the IOS support this command?</P><P></P><P>If not, does anyone know an alternative to test ACL/NAT rules in FWSM 2.3 without actually sending a real traffic thru it?</P><P></P><P>Thanks in Advance.</P> Mon, 11 Mar 2019 17:57:17 GMT https://community.cisco.com/t5/network-security/fwsm-2-3-packet-tracer/m-p/1474406#M663356 merryllem 2019-03-11T17:57:17Z Re: FWSM.2.3 (Packet-Tracer) https://community.cisco.com/t5/network-security/fwsm-2-3-packet-tracer/m-p/1474407#M663379 <HTML><HEAD></HEAD><BODY><P>Packet Tracer is not available to FWSM codes at the moment.</P><P></P><P>There is no simulation type commands that you can use with the FWSM code at the moment. You wqill have to test with real traffic, and check logs or do packet captures, to check for results.</P><P></P><P>Regards,</P></BODY></HTML> Thu, 10 Jun 2010 23:17:50 GMT https://community.cisco.com/t5/network-security/fwsm-2-3-packet-tracer/m-p/1474407#M663379 edadios 2010-06-10T23:17:50Z