topic Re: Integrating Cisco 4260 into IME 7.0(3) in Network Security

Integrating Cisco 4260 into IME 7.0(3)

rcianci — Sun, 10 Mar 2019 12:05:45 GMT

Hello all,

When trying to add a Cisco 4260 to IME I recieve the following message :

Could not verify config username/password [IOEXception - java.security.cert.CertificateException : The required certificate doesen't exist in the key store.]

Prior to this message I am displayed the certificate of the 4260 and I accept the certificate.

The Cisco 4260 is running version 7.0.(3)E4 and the version of IME is 7.0.3. I have 2 Cisco 4260 with the same problem.

I also regenerated one of the certificates on one of the IPS and the same condition - no luck.

The dashboard indicates the the device is there however I have Event Status - not connected. I have tried to Start - Event Connection and I recieve the following message :

Error occurs when start polling event (wrong sensor name)

( I also check the accounts and passwords used in the config and events account definitions)

Any suggestions?

Thanks

Bob

Re: Integrating Cisco 4260 into IME 7.0(3)

CY1234 — Thu, 19 Aug 2010 07:27:25 GMT

Hey Bob,

Can you try to log onto the sensor CLI and regenerate the certificate by issuing the command "tls regenerate-key".
Then re-add the sensor into IME and accept the new certificate when prompted.

Hope this helps.

Thanks,

--Sunil

Re: Integrating Cisco 4260 into IME 7.0(3)

rcianci — Wed, 01 Sep 2010 11:37:30 GMT

Hello Sunil,

Thanks for the suggestion. I had already tried to regenerate the key and no luck. I will be opening a case with Cisco after discussing it with my SE.

Thanks again,

Robert

Re: Integrating Cisco 4260 into IME 7.0(3)

scarpacci21 — Thu, 02 Sep 2010 14:39:06 GMT

HI Robert,

I have the same issue with IME 7.0.3 and two ASA-SSM-20.

Is your IME running on Windows Server 2008?

Regards,

Alan

Re: Integrating Cisco 4260 into IME 7.0(3)

rcianci — Thu, 02 Sep 2010 14:55:24 GMT

Hi Alan,

Yes, IME is running on a Windows 2008 server.

Thanks,

Bob

Re: Integrating Cisco 4260 into IME 7.0(3)

scarpacci21 — Thu, 02 Sep 2010 15:02:06 GMT

I just got it working...

Instead of simply launching IME from the desktop, I launched IME with the "Run as Administrator" option (Even though I'm RDC'd into the server with my domain Admin account). Then I removed both IPS devices and readded them. They started working instantly.

Hope this helps.

Regards,

Alan

Re: Integrating Cisco 4260 into IME 7.0(3)

rcianci — Thu, 02 Sep 2010 17:16:37 GMT

Hi Alan,

Thanks - your suggestion worked out great. The IPS devices are now in IME.

Thanks for your help,

Bob