topic Re: Pix 506 Full Duplex in Network Security https://community.cisco.com/t5/network-security/pix-506-full-duplex/m-p/58584#M670780 <HTML><HEAD></HEAD><BODY><P>I would manually configure the interfaces on the Router and the PIX to 10Mbps half-duplex. If this does not work I would check the cables. If it works I would then incresase the speed to 10 Mbps/Full duplex, and so on. But I do not agree with you not to use a switch to create the DMZ.</P><P></P><P>Good luck</P><P>Goran</P></BODY></HTML> Wed, 08 May 2002 21:54:23 GMT gradosavljevic 2002-05-08T21:54:23Z Pix 506 Full Duplex https://community.cisco.com/t5/network-security/pix-506-full-duplex/m-p/58583#M670748 <P>When I try to create my DMZ by placing an 8 port hub between my PIX 506 and Cisco 2600 series router I cannot get the PIX to link up. I thought I read something indicating that the 506 was set to auto-negotiate and was capable of Half Duplex communication. I havent tried to put a switch between the PIX and the Router to see if it gives me a link but even if it did I would not want to waste a switch to create my DMZ. Any suggestions?</P> Fri, 21 Feb 2020 06:02:56 GMT https://community.cisco.com/t5/network-security/pix-506-full-duplex/m-p/58583#M670748 r-higham 2020-02-21T06:02:56Z Re: Pix 506 Full Duplex https://community.cisco.com/t5/network-security/pix-506-full-duplex/m-p/58584#M670780 <HTML><HEAD></HEAD><BODY><P>I would manually configure the interfaces on the Router and the PIX to 10Mbps half-duplex. If this does not work I would check the cables. If it works I would then incresase the speed to 10 Mbps/Full duplex, and so on. But I do not agree with you not to use a switch to create the DMZ.</P><P></P><P>Good luck</P><P>Goran</P></BODY></HTML> Wed, 08 May 2002 21:54:23 GMT https://community.cisco.com/t5/network-security/pix-506-full-duplex/m-p/58584#M670780 gradosavljevic 2002-05-08T21:54:23Z