topic Re: Duplicate Active Signatures to Second Sensor in Network Security https://community.cisco.com/t5/network-security/duplicate-active-signatures-to-second-sensor/m-p/1388706#M68128 <HTML><HEAD></HEAD><BODY><P>There are several ways of accomplishing that goal. The most basic is from the</P><P>CLI. Log into Sensor 1 and display the full config (sh conf).</P><P>Log into sensor 2, get in the config mode (conf t) and paste in sensor 1's config for everything after the sig0 heading.</P></BODY></HTML> Mon, 18 Jan 2010 21:29:01 GMT rhermes 2010-01-18T21:29:01Z Duplicate Active Signatures to Second Sensor https://community.cisco.com/t5/network-security/duplicate-active-signatures-to-second-sensor/m-p/1388705#M68126 <P>I have 2 ASA-SSM-20 IPS modules on 2 different ASA 5520s.</P><P></P><P>I have setup the Signature Definitions for sig0 on Sensor 1 a certain way, how do I make those same policies apply to the sig0 on Sensor 2. I see that I can export the settings as a .csv from Sensor 1, but not how I can import them on Sensor 2?</P><P></P><P>Any help would be appreciated!</P> Sun, 10 Mar 2019 11:51:50 GMT https://community.cisco.com/t5/network-security/duplicate-active-signatures-to-second-sensor/m-p/1388705#M68126 jonpwil1970 2019-03-10T11:51:50Z Re: Duplicate Active Signatures to Second Sensor https://community.cisco.com/t5/network-security/duplicate-active-signatures-to-second-sensor/m-p/1388706#M68128 <HTML><HEAD></HEAD><BODY><P>There are several ways of accomplishing that goal. The most basic is from the</P><P>CLI. Log into Sensor 1 and display the full config (sh conf).</P><P>Log into sensor 2, get in the config mode (conf t) and paste in sensor 1's config for everything after the sig0 heading.</P></BODY></HTML> Mon, 18 Jan 2010 21:29:01 GMT https://community.cisco.com/t5/network-security/duplicate-active-signatures-to-second-sensor/m-p/1388706#M68128 rhermes 2010-01-18T21:29:01Z