topic Pix static map using PAT address in Network Security https://community.cisco.com/t5/network-security/pix-static-map-using-pat-address/m-p/7987#M697931 <P>I have an ISP that will only give out one ip address per MAC address. I am using PAT for outbound traffic but need to add a static mapping for incomming SMTP traffic. The static map command will not let you use an address in the PAT pool. Any ideas on a work around?</P> Fri, 21 Feb 2020 05:48:14 GMT jlentz 2020-02-21T05:48:14Z Pix static map using PAT address https://community.cisco.com/t5/network-security/pix-static-map-using-pat-address/m-p/7987#M697931 <P>I have an ISP that will only give out one ip address per MAC address. I am using PAT for outbound traffic but need to add a static mapping for incomming SMTP traffic. The static map command will not let you use an address in the PAT pool. Any ideas on a work around?</P> Fri, 21 Feb 2020 05:48:14 GMT https://community.cisco.com/t5/network-security/pix-static-map-using-pat-address/m-p/7987#M697931 jlentz 2020-02-21T05:48:14Z Re: Pix static map using PAT address https://community.cisco.com/t5/network-security/pix-static-map-using-pat-address/m-p/7988#M697950 <HTML><HEAD></HEAD><BODY><P>You can use the same IP for both the Static translation and MX entry (for SMTP traffic). We have implemented a number of projects where this is being done and it just works fine.</P><P></P><P>Regards / Sampath</P><P><A href="mailto:sampathsr@samw.com">sampathsr@samw.com</A></P></BODY></HTML> Thu, 07 Jun 2001 21:23:44 GMT https://community.cisco.com/t5/network-security/pix-static-map-using-pat-address/m-p/7988#M697950 sampathsr 2001-06-07T21:23:44Z