topic Re: Pix interface access in Network Security https://community.cisco.com/t5/network-security/pix-interface-access/m-p/374807#M711844 <HTML><HEAD></HEAD><BODY><P>Assuming, E0 is your outside address, the answer is no. You are going to need either console access or management access from the inside interface to accomplish this goal.</P><P></P><P>Scott</P></BODY></HTML> Tue, 29 Mar 2005 20:19:49 GMT scoclayton 2005-03-29T20:19:49Z Pix interface access https://community.cisco.com/t5/network-security/pix-interface-access/m-p/374806#M711808 <P>Hi;</P><P>If I need to telnet into a pix from outside and change the e0 address &amp; default route is there a way</P><P>to do that without getting disconnected, and without using inside interface or modem?</P><P>Thanks</P> Fri, 21 Feb 2020 08:02:37 GMT https://community.cisco.com/t5/network-security/pix-interface-access/m-p/374806#M711808 evans2005 2020-02-21T08:02:37Z Re: Pix interface access https://community.cisco.com/t5/network-security/pix-interface-access/m-p/374807#M711844 <HTML><HEAD></HEAD><BODY><P>Assuming, E0 is your outside address, the answer is no. You are going to need either console access or management access from the inside interface to accomplish this goal.</P><P></P><P>Scott</P></BODY></HTML> Tue, 29 Mar 2005 20:19:49 GMT https://community.cisco.com/t5/network-security/pix-interface-access/m-p/374807#M711844 scoclayton 2005-03-29T20:19:49Z Re: Pix interface access https://community.cisco.com/t5/network-security/pix-interface-access/m-p/374808#M711873 <HTML><HEAD></HEAD><BODY><P>**Correction**</P><P></P><P>Assuming E0 is your outside INTERFACE, the answer is no.</P></BODY></HTML> Tue, 29 Mar 2005 20:20:39 GMT https://community.cisco.com/t5/network-security/pix-interface-access/m-p/374808#M711873 scoclayton 2005-03-29T20:20:39Z