topic Re: Can I make single context failover preemptive in Network Security https://community.cisco.com/t5/network-security/can-i-make-single-context-failover-preemptive/m-p/1421746#M730067 <HTML><HEAD></HEAD><BODY><P>That is correct. Preempt is only available in multiple context act/act mode. Pls. refer to the table in the below command reference link below:</P><P></P><P><A class="jive-link-external-small" href="http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/p.html#wp1868647">http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/p.html#wp1868647</A></P><P></P><P>-KS</P></BODY></HTML> Fri, 19 Feb 2010 14:19:10 GMT Kureli Sankar 2010-02-19T14:19:10Z Can I make single context failover preemptive https://community.cisco.com/t5/network-security/can-i-make-single-context-failover-preemptive/m-p/1421744#M730063 <P>Hello,</P><P>I have two firewalls in layer 3 mode, single context, active - standby.</P><P>Is it possible to make the primary after a failure to become active again, without having to type failover active?</P><P>thanks,</P><P>george</P> Mon, 11 Mar 2019 17:12:13 GMT https://community.cisco.com/t5/network-security/can-i-make-single-context-failover-preemptive/m-p/1421744#M730063 g.eleftheriou 2019-03-11T17:12:13Z Re: Can I make single context failover preemptive https://community.cisco.com/t5/network-security/can-i-make-single-context-failover-preemptive/m-p/1421745#M730065 <HTML><HEAD></HEAD><BODY><P>No.</P><P></P><P>Preempt only work in Active/Active failover mode.</P><P></P><P>Active/Active work in multiple context mode.</P></BODY></HTML> Fri, 19 Feb 2010 11:07:23 GMT https://community.cisco.com/t5/network-security/can-i-make-single-context-failover-preemptive/m-p/1421745#M730065 francisco_1 2010-02-19T11:07:23Z Re: Can I make single context failover preemptive https://community.cisco.com/t5/network-security/can-i-make-single-context-failover-preemptive/m-p/1421746#M730067 <HTML><HEAD></HEAD><BODY><P>That is correct. Preempt is only available in multiple context act/act mode. Pls. refer to the table in the below command reference link below:</P><P></P><P><A class="jive-link-external-small" href="http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/p.html#wp1868647">http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/p.html#wp1868647</A></P><P></P><P>-KS</P></BODY></HTML> Fri, 19 Feb 2010 14:19:10 GMT https://community.cisco.com/t5/network-security/can-i-make-single-context-failover-preemptive/m-p/1421746#M730067 Kureli Sankar 2010-02-19T14:19:10Z