topic NAC OOB in Network Security

NAC OOB

saxenanitesh8522 — Fri, 21 Feb 2020 11:57:34 GMT

hey,

I am new to NAC and i have to implement NAC OOB in my project

i am confused over somepoints

1. When i boot the NAC appliance can i directly access the web gui or do i have to go through

cli and configure e0 first and then access the gui?

2. user role mapping do i have to map tat with my switch role or vice-versa?

3. vlan mapping- i have to role base port profiles for assignment of the vlan from unauth to access vlan right??

please it would be a great help. thank you

Re: NAC OOB

Faisal Sehbai — Fri, 14 May 2010 19:43:20 GMT

Nitesh,

1. You have to configure it first through CLI so it can get an IP address. When you initially boot a CAM or CAS, it will walk you through the config script. If it doesn't for some reason, you can always launch it by using "service perfigo config" command from the CLI

2. Roles are defined in the CAM, not on switch. The VLANs however will be defined on the switches.

3. Unclear on the question but I think the answer is yes?

In any case before you start off on this project I would highly recommend you go through all the chalk talks on this link to give you a good idea of how to design and implement CCA: http://bit.ly/chalktalks

HTH,

Faisal

Re: NAC OOB

saxenanitesh8522 — Sat, 15 May 2010 04:00:26 GMT

hey,

no actually i wanted to know that do we have to map our user profile with switch profile?

like we do in posture assesement

secondly, those are just audio, no video is coming...

Re: NAC OOB

Faisal Sehbai — Mon, 17 May 2010 02:20:30 GMT

Nitesh,

No, it's not like the posture assessment piece. User profiles and Switch profiles are separate.

HTH,

Faisal