topic Re: Change IPS to IDS in Network Security https://community.cisco.com/t5/network-security/change-ips-to-ids/m-p/1162466#M77785 <HTML><HEAD></HEAD><BODY><P>The 4240 has 4 ports. One (in-line VLAN pairs) or two (in-line interface pairs) of those ports are being used. If you have a free port, put it in promiscious mode (default) and connect it to a new port on the switch that is aggregating your traffic. Configure the new switch interface as a span destination port. then disconnect your in-line interfaces (restoring traffic via another path of course).</P></BODY></HTML> Mon, 09 Feb 2009 19:32:37 GMT rhermes 2009-02-09T19:32:37Z Change IPS to IDS https://community.cisco.com/t5/network-security/change-ips-to-ids/m-p/1162465#M77781 <P>Hi All, </P><P>I have an IPS Sensor 4240 working inline with the default settings... I need to do some tests and I need to change it to behave as an IDS. I know that I should configure the port on the swith as a SPAN port to send all traffic to the IDS (that will no longer be inline).... </P><P>My question is... what do I need to do in the IPS Sensor to change it to IDS? </P><P>Thank you all!</P><P></P> Sun, 10 Mar 2019 11:29:30 GMT https://community.cisco.com/t5/network-security/change-ips-to-ids/m-p/1162465#M77781 fedecotofaja 2019-03-10T11:29:30Z Re: Change IPS to IDS https://community.cisco.com/t5/network-security/change-ips-to-ids/m-p/1162466#M77785 <HTML><HEAD></HEAD><BODY><P>The 4240 has 4 ports. One (in-line VLAN pairs) or two (in-line interface pairs) of those ports are being used. If you have a free port, put it in promiscious mode (default) and connect it to a new port on the switch that is aggregating your traffic. Configure the new switch interface as a span destination port. then disconnect your in-line interfaces (restoring traffic via another path of course).</P></BODY></HTML> Mon, 09 Feb 2009 19:32:37 GMT https://community.cisco.com/t5/network-security/change-ips-to-ids/m-p/1162466#M77785 rhermes 2009-02-09T19:32:37Z