topic Re: IPS IOS UPGRADE 4240 in Network Security

IPS IOS UPGRADE 4240

CSCO10320953 — Sun, 10 Mar 2019 11:22:48 GMT

ROMMON Variable Settings:

ADDRESS=172.16.X.X ---MANAGEMNET IP

SERVER=172.16.x.x----TFTP SERVER IP

GATEWAY=172.16.X.X -------MANAGEMNET IP

PORT=Management0/0

VLAN=untagged

IMAGE=IPS-K9-6.1-1-E1.pkg

CONFIG=

LINKTIMEOUT=20

PKTTIMEOUT=4

RETRY=20

tftp IPS-K9-6.1-1-E1.pkg@172.16.X.X via 172.16.X.X

TFTP failure: Packet verify failed after 20 retries

OBSERVATION:

I am doing the ios upgration from IPS-K9-5.1-6-E1 to IPS-K9-6.1-1-E1.pkg

1. rommon #12>---

once coming rommon mode i am not able to ping 172.16.x.x manage ip.

2.TFTP failure: Packet verify failed after 20 retries

3.all same network only

How to do solve the problem or give me idea

Thanks.

Re: IPS IOS UPGRADE 4240

rhoud — Mon, 17 Nov 2008 16:02:57 GMT

The problem is your trying to do install a upgrade package from rommon. You can only install system images using this method (IPS-4240-K9-sys-1.1-a-6.1-1-E2.img. To upgrade you need to reboot the sensor and let it come back up then issue:

(conf)#upgrade ftp://@X.X.X.X///IPS-K9-6.1-1-E1.pkg. By upgrading you will save all your config changes and sig tunings. Where as a system image will bring your sensor back to default configuration with the new image.

Hope this helps,

rhoud

Re: IPS IOS UPGRADE 4240

CSCO10320953 — Mon, 17 Nov 2008 17:22:52 GMT

Thanks for good info.Customer will give the down time with in week.Once i complete the work and do the rating ...

Re: IPS IOS UPGRADE 4240

CSCO10320953 — Sat, 22 Nov 2008 01:38:19 GMT

After upgration IPS-4240-K9-sys-1.1-a-5.0-2.img to IPS-4240-K9-sys-1.1-a-6.1-1-E3.img i am getting below message

There is no license key installed on the IPS-4240. The system will continue to operate with the currently installed signature set. A valid license must be obtained in order to apply signature updates. Please go to http://www.cisco.com/go/license

to obtain a new license or install a license. Its not going to promt mode ?

How can i go to ips configuration mode?

Any steps which are to be done first?