topic Re: ASA management in Network Security

ASA management

joet8591 — Mon, 11 Mar 2019 16:31:52 GMT

When running two ASAs as Active/Standby; is there a way to have two different management addresses using two different networks?

(In a failure each ASA should keep its mgmt address. Basically exclude the mgmt interface from config synchronization.)

Thanks

Joe

Re: ASA management

francisco_1 — Tue, 27 Oct 2009 12:41:07 GMT

yes you can have both devices on different management address and exclude from failover monitor...But you can only make active configuration chaange on the active device though!

Re: ASA management

Jatin Katyal — Tue, 27 Oct 2009 12:44:01 GMT

Hi,

It should be from the same network.

HTH

Re: ASA management

francisco_1 — Tue, 27 Oct 2009 12:47:08 GMT

yep. forgot to mentioned that. thanks JK.

Re: ASA management

joet8591 — Wed, 28 Oct 2009 19:28:15 GMT

Would that require using the "standby" ip address on the mgmt interface with two different IPs but on the same subnet?

(I was hoping that the mgt interface config was not "synchronized.)

Thanks

Joe